| Caliber diameter on inner ring wide side face | d2 | 39.50 | mm |
| Contact angle | α | 40 | ° |
| Shoulder diameter on outer ring wide side face | D1 | 49.50 | mm |
| Caliber diameter on outer ring small side face | D3 | 57.10 | mm |
| Distance between the apexes of the pressure cones | a | 27 | mm |
| Minimum chamfer dimension | rmin | 0.60 | mm |
| Caliber diameter on outer ring wide side face | D2 | 51.70 | mm |
| Shoulder diameter on inner ring wide side face | d1 | 43.20 | mm |
| Bore diameter | d | 30 | mm |
| Width | B | 16 | mm |
| Basic static load rating, radial | C0r | 14,100 | |
| Limiting speed | nG | 6,500 |
| Outside diameter | D | 62 | mm |
| Basic dynamic load rating, radial | Cr | 23,100 | |
| Fatigue load limit, radial | Cur | 980 | N |
| Minimum diameter of shaft shoulder | da min | 35.60 | mm |
| Maximum diameter of housing shoulder | Db max | 57.80 | mm |
| Maximum fillet radius of housing | ra1 max | 0.60 | mm |
| Maximum diameter of housing shoulder | Da max | 56.40 | mm |
| Maximum fillet radius of shaft | ra max | 1 | mm |
