a)
Lubricating hole M8 x 1 sealed with plastic cap
| S2 (Fixing screws ISO 4762-8.8) | 8.40 | ||
| SW | 5 | ||
| D | 47 | mm | |
| E3 | 106 mm ±0.15 | ||
| E5 | 52 | ||
| H | 35 | mm | |
| H1 | 70 | mm | |
| H4 | 22 | mm | |
| m (Clamped (fastened) in relation to Ø d.) | 43.5 mm ±0.01 | ||
| N3 | 22 | mm |
| S4 (Pin hole centering.) | 6 | mm | |
| V | 8 | mm | |
| B1 | 87 | mm | |
| E4 | 68 mm ±0.15 | ||
| E6 | 72 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 16 | mm | |
| L | 152 | mm | |
| N2 | 34 | mm | |
| S3 | M10 |
| amax | 150 | m/s² | |
| m | 2.01 | kg | |
| Breakaway force | 6 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 2.50 | N | |
| Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
