a)
Lubricating hole sealed with plastic cap
| S1 | M10 | ||
| V | 6.50 | mm | |
| D | 40 | mm | |
| A | 78 | mm | |
| E2 | 40 mm ±0.15 | ||
| E4 | 20 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 10 | mm | |
| L | 67 | mm | |
| m (Clamped (fastened) in relation to Ø d.) | 39 mm ±0.01 | ||
| N2 | 22 | mm | |
| S2 (Pin hole centering.) | 6 |
| SW | 3 | ||
| W (Minimum size in relation to Ø d.) | 11.50 | mm | |
| A | 57 | mm | |
| E1 | 60 mm ±0.15 | ||
| E3 | 64 | mm | |
| H | 30 | mm | |
| H1 | 51 | mm | |
| H4 | 4 | mm | |
| l3 | 15 | ||
| N1 | 29 | mm | |
| S (Fixing screws ISO 4762-8.8) | 8.40 |
| amax | 150 | m/s² | |
| m | 0.57 | kg | |
| Breakaway force | 4.50 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 2 | N | |
| Shaft radial clearance h6 (Clamped (fastened).) | + 31 - 2 |
||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
