a)
Lubricating hole sealed with plastic cap
| S1 | M6 | ||
| V | 5 | mm | |
| D | 26 | mm | |
| A | 53 | mm | |
| E2 | 26 mm ±0.15 | ||
| E4 | 35 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 10 | mm | |
| L | 43 | mm | |
| m (Clamped (fastened) in relation to Ø d.) | 26.5 mm ±0.01 | ||
| N2 | 13 | mm | |
| S2 (Pin hole centering.) | 4 |
| SW | 2.50 | ||
| W (Minimum size in relation to Ø d.) | 9 | mm | |
| A | 68 | mm | |
| E1 | 40 mm ±0.15 | ||
| E3 | 42 | mm | |
| H | 22 | mm | |
| H1 | 35 | mm | |
| H4 | 2.50 | mm | |
| l3 | 11.50 | ||
| N1 | 21 | mm | |
| S (Fixing screws ISO 4762-8.8) | 5.30 |
| amax | 150 | m/s² | |
| m | 0.17 | kg | |
| Breakaway force | 2 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1 | N | |
| Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
