| B (Tolerance ISO 8062-3 - DCTG 9.) | 54 | ||
| SW | 3 | ||
| W (Minimum size in relation to Ø d.) | 11.50 | mm | |
| A | 57 | mm | |
| E1 | 60 mm ±0.15 | ||
| H | 30 | mm | |
| H2 (Tolerance ISO 8062-3 - DCTG 9.) | 51 | mm | |
| S | 5.50 |
| B1 | 40 | mm | |
| V (Tolerance ISO 8062-3 - DCTG 9.) | 9 | mm | |
| D | 40 | mm | |
| A (Tolerance ISO 8062-3 - DCTG 9.) | 74 | mm | |
| E2 | 40 mm ±0.15 | ||
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| L | 58 | mm |
| amax | 150 | m/s² | |
| m | 0.70 | kg | |
| Breakaway force | 4.50 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 2 | N | |
| Shaft radial clearance h6 | + 31 + 2 |
||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
