a)
Vent hole
b)
Lubricating hole M8 x 1 sealed with plastic cap
| N1 | 89 | mm | |
| S1 | M16 | ||
| B | 130 | ||
| E2 | 100 mm ±0.2 | ||
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 20 | mm | |
| N | 34 | mm |
| S (Fixing screws ISO 4762-8.8) | 13.50 | ||
| D | 75 | mm | |
| E1 | 125 mm ±0.2 | ||
| H | 50 | mm | |
| H1 | 105 | mm | |
| L | 224 | mm |
| amax | 150 | m/s² | |
| m | 6.30 | kg | |
| Breakaway force | 10 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 4 | N | |
| Shaft radial clearance h6 | + 50 + 12 |
||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
