a)
Lubricating hole sealed with plastic cap
| A | 52 | mm | |
| D | 75 | mm | |
| E2 | 50 mm ±0.2 | ||
| E4 | 85 | mm | |
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 8 - 16 |
||
| H3 | 12.50 | mm | |
| L | 101 | mm | |
| m (Clamped (fastened) in relation to Ø d.) | 66 mm ±0.01 | ||
| N2 | 34 | mm | |
| S1 | M16 | ||
| SW | 5 | ||
| W | 22.10 | mm |
| A | 132 | mm | |
| E1 | 108 mm ±0.2 | ||
| E3 | 108 | mm | |
| H | 50 | mm | |
| H1 | 88 | mm | |
| H4 | 6 | mm | |
| l3 | 39 | ||
| N1 | 49 | mm | |
| S | 13.50 | ||
| S2 | 10 | ||
| V | 12 | mm |
| amax | 150 | m/s² | |
| m | 2.30 | kg | |
| Breakaway force | 22.50 | N | |
| Operating conditions | Operating conditions |
| vmax | 5 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 9 | N | |
| Radial clearance | Comes clamped to h5 shaft (lower limit) and set to zero clearance | ||
| Permissible ambient temperature (min ... max) | -20 °C ... +80 °C |
