| Minimum diameter shaft | da min | 45 | mm |
| Size of fixing screws | M8 | ||
| Pitch separation angle of holes in adjacent construction | ta | 90 | ° |
| Maximum diameter of housing | Da max | 62 | mm |
| Position tolerance of bore in the housing | t1 | 0.20 | mm |
| Number of holes in adjacent construction | na | 4 | |
| Connection thread for lubrication | M6 |
| Rib diameter inner ring | d1 | 52 | mm |
| Pitch circle diameter fixing holes | m | 75 | mm |
| Width of extraction slot | b | 3 | mm |
| Pitch quantity of fixing holes | n | 8 | |
| Contact angle | α | 60 | ° |
| Minimum chamfer dimension | rmin | 0.60 | mm |
| Fixing holes diameter | d2 | 8.80 | mm |
| Distance of extraction slot | I | 25 | mm |
| Pitch separation angle of fixing holes | t | 45 | ° |
| Bore diameter | d | 35 | mm |
| Outside diameter | D | 90 | mm |
| Width | B | 34 | mm |
| Basic dynamic load rating, axial | Ca | 41,000 | |
| Fatigue load limit, axial | Cua | 4,050 | |
| Thermally safe operating speed | nϑ | 2,000 |
| Bore diameter lower tolerance | -0.01 | mm | |
| Outside diameter lower tolerance | -0.02 | mm | |
| Width lower tolerance | -0.25 | mm | |
| Basic static load rating, axial | C0a | 89,000 | |
| Limiting speed for grease lubrication | nG Grease | 4,400 | |
| Bearing frictional torque | MR | 0.60 | Nm |
